Description
PIR Occupancy Sensor for Bi-Level Fixture Lighting - 10-14V DC and 0-10V Dimming
The WSD LED NLC-MW-SQ-008 is a low-voltage PIR occupancy sensor with bi-level dimming and daylight harvesting that mounts inside an indoor LED fixture. It is powered by the fixture's 10-14V DC auxiliary output and dims 0-10V drivers.
Key Features
- Bi-level control: dims to a standby level, then off, when the space empties
- Daylight harvesting: keeps lights off when daylight is sufficient; set it up with the RC-100 remote
- Fixture mount: installs in the fixture, powered by its 10-14V DC auxiliary
- Remote setup: hold time, task level and standby level are set with the RC-100 remote, sold separately
Applications
- Wraparound and linear fixtures in stairwells
- Storage rooms and corridors
- Restrooms and break rooms
Product Specifications
- Manufacturer model: NLC-MW-SQ-008
- Sensor type: Passive infrared (PIR)
- Power supply: 10-14V DC, over 50 mA
- Dim control output: 0-10V
- Mounting height: 12 ft (4 m) max
- Detection angle: 360 degrees
- Operating temperature: -4 to 140 F
- IP rating: IP20
- Factory default: 100% brightness, 5 min hold, 30% standby level
Alternatives
- Sharkward NLC-MW-SQ-005 - Low Voltage Microwave Bi-Level Sensor - Full 360 deg Detection
- WSD LED NLC-MW-SQ-006 - Bi-Level Microwave Sensor - 12-24V DC
- NLC-MW-SQ-007 - Low Voltage Bi-Level Motion Sensor
Compatible Products
Sold separately unless noted. Fit is based on the WSD spec sheet or WSD listing noted below.
- WSD-RP2FT12162025W27-5CCT - 5CCT 2 ft Selectable LED Wraparound Light: 2 ft wraparound that lists this sensor
- WSD-RP4FT24313846W27-5CCT - 5CCT 4 ft Selectable LED Wraparound Light: 4 ft wraparound that lists this sensor
- RC-100 Microwave Sensor Remote Control: RC-100 remote for setup
Additional Notes
- Remote: The RC-100 remote is sold separately and is needed to change settings and enable daylight harvesting
- Warm-up: Lights stay on for 40 seconds at first power-up, then normal operation begins
Frequently Asked Questions
Is the remote included?
No. WSD packs the sensor alone. The RC-100 remote is sold separately.
What power does it need?
10-14V DC at over 50 mA, from the fixture auxiliary output.
How high can it mount?
Up to 12 ft.
Downloads
Disclaimers
- Selection: Verify the exact model and installation requirements before ordering.
- Installation: Follow the manufacturer instructions and applicable electrical codes.
*This product typically ships in 2 to 3 business days. Larger quantities may take longer than stated lead-time. All lead-times are estimates and you will be notified by email if it will take longer than 5 business days to ship.
